Памет 4GB DDR4 2666MHz, Kingston KVR26N19S6/4, 1.2V

Kingston KVR26N19S6/4


This document describes ValueRAM's KVR26N19S6/4 is a 512M
x 64-bit (4GB) DDR4-2666 CL19 SDRAM (Synchronous DRAM),
1Rx16, memory module, based on four 512M x 16-bit FBGA
components. The SPD is programmed to JEDEC standard
latency DDR4-2666 timing of 19-19-19 at 1.2V. Each 288-pin
DIMM uses gold contact fingers. The electrical and mechanical
specifications are as follows:

Power Supply: VDD = 1.2V Typical
VDDQ = 1.2V Typical
VPP = 2.5V Typical
VDDSPD = 2.2V to 3.6V
Nominal and dynamic on-die termination (ODT) for data, strobe, and mask signals
Low-power auto self refresh (LPASR)
Data bus inversion (DBI) for data bus
On-die VREFDQ generation and calibration
Single-rank
On-board I2 serial presence-detect (SPD) EEPROM
8 internal banks; 2 groups of 4 banks each
Fixed burst chop (BC) of 4 and burst length (BL) of 8 via the mode register set (MRS)
Selectable BC4 or BL8 on-the-fly (OTF)
Fly-by topology
Terminated control command and address bus
PCB: Height 1.23” (31.25mm)
RoHS Compliant and Halogen-Free

CL(IDD) : 19 cycles
Row Cycle Time (tRCmin) : 45.75ns(min.)
Refresh to Active/Refresh : 350ns(min.)
Command Time (tRFCmin)
Row Active Time (tRASmin) : 32ns(min.)
Maximum Operating Power : TBD W
UL Rating : 94 V - 0
Operating Temperature : 0C to 85C
Storage Temperature : -55C to +100C


Виж още Настолни компютри Памети Kingston
Виж всички Настолни компютри Памети в категорията