HyperX Fury
HX424C15FBK2/32
HyperX HX424C15FBK2/32 is a kit of two 2G x 64-bit (16GB)
DDR4-2400 CL15 SDRAM (Synchronous DRAM) 2Rx8, memory
module, based on sixteen 1G x 8-bit FBGA components per module.
Each module kit supports Intel® Extreme Memory Profiles
(Intel® XMP) 2.0. Total kit capacity is 32GB. Each module has
been tested to run at DDR4-2400 at a low latency timing of 15-15-15
at 1.2V. Additional timing parameters are shown in the
Plug-N-Play (PnP) Timing Parameters section below. The
JEDEC standard electrical and mechanical specifications are
as follows:
JEDEC/XMP TIMING PARAMETERS
• JEDEC/PnP: DDR4-2400 CL15-15-15 @1.2V
DDR4-2133 CL14-14-14 @1.2V
•XMP Profile #1: DDR4-2400 CL15-15-15 @1.2V
SPECIFICATIONS
CL(IDD)-15 cycles
Row Cycle Time (tRCmin)-46.75ns(min.)
Refresh to Active/Refresh-350ns(min.)
Command Time (tRFCmin)
Row Active Time (tRASmin)-29.125ns(min.)
Maximum Operating Power-TBD W*
UL Rating-94 V - 0
Operating Temperature-0oC to +85oC
Storage Temperature--55oC to +100oC
FEATURES
Power Supply: VDD = 1.2V Typical
• VDDQ = 1.2V Typical
• VPP - 2.5V Typical
• VDDSPD = 2.2V to 3.6V
• Nominal and dynamic on-die termination (ODT) for
data, strobe, and mask signals
• Low-power auto self refresh (LPASR)
• Data bus inversion (DBI) for data bus
• On-die VREFDQ generation and calibration
• Dual-rank
• On-board I2 serial presence-detect (SPD) EEPROM
• 16 internal banks; 4 groups of 4 banks each
• Fixed burst chop (BC) of 4 and burst length (BL) of 8
via the mode register set (MRS)
• Selectable BC4 or BL8 on-the-fly (OTF)
• Fly-by topology
• Terminated control command and address bus
• Height 1.340” (34.04mm), w/heatsink
HyperX is a division of Kingston.
Виж още Настолни компютри Памети HyperX
Виж всички Настолни компютри Памети в категорията
HX424C15FBK2/32
HyperX HX424C15FBK2/32 is a kit of two 2G x 64-bit (16GB)
DDR4-2400 CL15 SDRAM (Synchronous DRAM) 2Rx8, memory
module, based on sixteen 1G x 8-bit FBGA components per module.
Each module kit supports Intel® Extreme Memory Profiles
(Intel® XMP) 2.0. Total kit capacity is 32GB. Each module has
been tested to run at DDR4-2400 at a low latency timing of 15-15-15
at 1.2V. Additional timing parameters are shown in the
Plug-N-Play (PnP) Timing Parameters section below. The
JEDEC standard electrical and mechanical specifications are
as follows:
JEDEC/XMP TIMING PARAMETERS
• JEDEC/PnP: DDR4-2400 CL15-15-15 @1.2V
DDR4-2133 CL14-14-14 @1.2V
•XMP Profile #1: DDR4-2400 CL15-15-15 @1.2V
SPECIFICATIONS
CL(IDD)-15 cycles
Row Cycle Time (tRCmin)-46.75ns(min.)
Refresh to Active/Refresh-350ns(min.)
Command Time (tRFCmin)
Row Active Time (tRASmin)-29.125ns(min.)
Maximum Operating Power-TBD W*
UL Rating-94 V - 0
Operating Temperature-0oC to +85oC
Storage Temperature--55oC to +100oC
FEATURES
Power Supply: VDD = 1.2V Typical
• VDDQ = 1.2V Typical
• VPP - 2.5V Typical
• VDDSPD = 2.2V to 3.6V
• Nominal and dynamic on-die termination (ODT) for
data, strobe, and mask signals
• Low-power auto self refresh (LPASR)
• Data bus inversion (DBI) for data bus
• On-die VREFDQ generation and calibration
• Dual-rank
• On-board I2 serial presence-detect (SPD) EEPROM
• 16 internal banks; 4 groups of 4 banks each
• Fixed burst chop (BC) of 4 and burst length (BL) of 8
via the mode register set (MRS)
• Selectable BC4 or BL8 on-the-fly (OTF)
• Fly-by topology
• Terminated control command and address bus
• Height 1.340” (34.04mm), w/heatsink
HyperX is a division of Kingston.
Виж още Настолни компютри Памети HyperX
Виж всички Настолни компютри Памети в категорията
Технически характеристики
Капацитет: | 32 (2x16) GB |
---|---|
Тип: | DDR4 |
Добави Ревю / Въпрос
Оцени продукта или задай въпрос?
0.00 от 0 ревюта
- 5
- 4
- 3
- 2
- 1