Памет 8GB DDR4 2666Mhz, Kingston HyperX Fury Red HX426C16FR2/8, 1.2V

Kingston HyperX Fury Red HX426C16FR2/8

HyperX HX426C16FR2/8 is a 1G x 64-bit (8GB) DDR4-2666 CL16 SDRAM (Synchronous DRAM) 1Rx8, memory module, based on eight 1G x 8-bit FBGA components per module. Each module supports Intel® Extreme Memory Profiles (Intel® XMP) 2.0.
Each module has been tested to run at DDR4-2666 at a low latency timing of 16-18-18 at 1.2V. Additional timing parameters are shown in the Plug-N-Play (PnP) Timing Parameters section below. The JEDEC standard electrical and mechanical specifications are as follows:

CL(IDD) : 16 cycles
Row Cycle Time (tRCmin) : 45.75ns(min.)
Refresh to Active/Refresh Command Time (tRFCmin) : 350ns(min.)
Row Active Time (tRASmin) : 29.25ns(min.)
Maximum Operating Power : TBD W*
UL Rating : 94 V - 0
Operating Temperature : 0 C to +85 C
Storage Temperature : -55 C to +100 C

Power Supply: VDD = 1.2V Typical
• VDDQ = 1.2V Typical
• VPP - 2.5V Typical
• VDDSPD = 2.2V to 3.6V
• Nominal and dynamic on-die termination (ODT) for
data, strobe, and mask signals
• Low-power auto self refresh (LPASR)
• Data bus inversion (DBI) for data bus
• On-die VREFDQ generation and calibration
• Single-rank
• On-board I2 serial presence-detect (SPD) EEPROM
• 16 internal banks; 4 groups of 4 banks each
• Fixed burst chop (BC) of 4 and burst length (BL) of 8
via the mode register set (MRS)
• Selectable BC4 or BL8 on-the-fly (OTF)
• Fly-by topology
• Terminated control command and address bus
• Height 1.340” (34.04mm), w/o heatsink



Виж още Настолни компютри Памети Kingston
Виж всички Настолни компютри Памети в категорията